A bathroom mirror is a necessary item that may be found in each bathroom across the world. Bathroom mirrors are amazing ornamental items that considerably enhance the appearance and feel of a bathroom in addition to their usefulness. Bathroom mirrors are divided into two categories: framed and frameless. In order for a mirror to be firmly mounted on the wall in your bathroom, it must be properly hung.

Step 1: Decide on a location

Choose where you want your bathroom mirror to be. Bathroom mirrors are best situated below a bathroom sink, but you may put them anywhere you like as long as they are not too high or too low.

Step 2: Put the Mirror in Its Rightful Place on the Wall

Allow a coworker to hold the mirror against the wall and position it so that the mid-point markers for both are aligned. The margins of the wall mirror should be softly outlined with a pencil.

Step 3: Work on the Drywall

Using a stud finder, locate the two studs at the back of the drywall where the mirror will be mounted. Make a pencil mark on the spot where it will be. To keep the mirror level on the wall, draw a line halfway between the studs with a level.

Step 4: Put the J-Clips in place.

Attach the bottom to the wall with two J-clips and flathead wood screws, following the markings. The anchored pieces’ tops must be secured to the wall. The two J-clips should be slid into the anchors lightly.

Step 5: Glue the Bathroom Mirror to the Wall

Insert the bathroom mirror into the J-clips at the bottom. The clips must be forced down so that the ends of the clips go over the mirror’s rim and fasten it to the wall.

Hanging a Mirror with Frame

Step 1: Attach Screws to a Framed Mirror

Fasten eye screws behind the mirror frame to install a bathroom mirror with a frame. Attach one eye screw to the left side of your mirror frame, 2 inches higher than the vertical center. The other screw should be attached to the right side as well.

Step 2: Connect the Wire

Determine what kind of wire to use to hang the framed mirror. Using pliers, wrap the wire around one eye screw and tighten it tightly. Allow enough wire extension for the opposite side to be completed in the same manner.

Step 3: Check to see if a stud is present

With a pencil, make a mark on the wall. Use a stud finder to see whether there is a stud and if there is, all you need are a couple of screws to secure the framed bathroom mirror to the bathroom wall. If there are no studs at your selected site, you may either choose a new place with studs or use a hollow wall anchor to secure the mirror to the wall.

Step 4: Attach the Nail to the Mirror

Hold the mirror in place and raise the wire from the middle. Determine the distance between the bottom of the frame and the top of the wire’s mid-point to determine where the nail should be attached and the Bathroom Mirror and Framed Mirror.

Step 5: Glue the Mirror to the Wall

Pick up the mirror and place it on the nail that was previously put. Make sure the mirror is positioned properly on the wall.